| If the mural is furnished in sections, begin with the far left panel and work to the right. |
| Step 1 |
Using a low pile paint roller, apply a thin coat of VOV wallpaper paste to the wall. If the mural is
furnished in sections, apply the paste only to the area that will be covered by the first panel.
Click here or on the image for a larger view. |
 |
| Step 2 |
Set up a table nearby the place where you will be installing the mural. Lay the mural over the table.
Apply a thin coat of VOV wallpaper paste to the back of the vinyl. For ease of handling, the vinyl panels may be loosely
folded after the paste is applied to that area. Avoid hard creases.
Click here or on the image for a larger view. |
 |
| Step 3 |
Apply the vinyl to the wall loosely, adjusting it for proper alignment. Using a damp sponge, begin
lightly rubbing the mural, from the center outward, in order to remove any air bubbles. Continue until all of the
air bubbles are removed. Using the damp sponge, remove any wallpaper paste that is on the surface of the mural.
Click here or on the image for a larger view. |
 |
| Step 4 |
Carefully align the next panel. There is a one inch overlay of the mural that will allow you to match
the edge of this panel to the panel previously installed. Follow the instructions in step 3 to install this panel.
Continue this process until all panels have been installed. If the mural is a wall-to-wall installation, the last
panel will be slightly oversized and require trimming. Trim any excess material at the top and bottom of the mural
as well.
Click here or on the image for a larger view. |
 |
